Aside from the stock oil pressure sending unit.
Is there another place i can connect an oil pressure guage.
The stock pressure unit mount had to be welded shut.
If i can stop it deom leaking i will need another place to run an oil pressure guage.
Oil pressure guage
-
- Passed the Circle Test
- Posts: 395
- Joined: Mon Apr 04, 2016 11:13 am
- My Bike: 1988 1400cc Intruder
- Location: Los Angeles
- Herb
- Joined a 1200cc Club
- Posts: 19314
- Joined: Sun Oct 26, 2014 9:28 pm
- My Bike: 1999 1400 intruder
Re: Oil pressure guage
on page 5-24 of the manual there is a picture of a point to hook up an oil pressure gauge for testing. it is on the lower front, right side of the engine, just inside the frame loop.
I can't seem to win the lottery. I think I have used up all of my good luck riding motorcycles.
-
- Passed the Circle Test
- Posts: 395
- Joined: Mon Apr 04, 2016 11:13 am
- My Bike: 1988 1400cc Intruder
- Location: Los Angeles
Re: Oil pressure guage
That is where the stock sensor goes right?
- Herb
- Joined a 1200cc Club
- Posts: 19314
- Joined: Sun Oct 26, 2014 9:28 pm
- My Bike: 1999 1400 intruder
Re: Oil pressure guage
that would be a no.PrinceMo wrote:That is where the stock sensor goes right?
If you look closely at the drawing on page 5-27 you will see a plug on the oil gallery, kind of below where the oil sending unit comes out. I believe that is where you would tap in for the oil pressure. There is another plug below and behind the oil filter but I don't know if it is pressure or return.
I can't seem to win the lottery. I think I have used up all of my good luck riding motorcycles.
-
- Passed the Circle Test
- Posts: 395
- Joined: Mon Apr 04, 2016 11:13 am
- My Bike: 1988 1400cc Intruder
- Location: Los Angeles
Re: Oil pressure guage
Thanks