To the dumbasses who have trouble reading due to their butthurt - I'll spell it out again...
All I was saying was be careful how you use hammers around the magnets in these rotors.
Pull the thing off whatever way you want but just be careful because you can easily fuck them up by hitting them.
Rotor Remover
- Designer
- Joined a 1200cc Club
- Posts: 17400
- Joined: Tue Sep 16, 2014 8:34 am
- My Bike: Two 1400 Custom Made Choppers
Re: Rotor Remover
To the antagonistic ones who cannot accept they were mistaken in what they read and then also in lecturing others.
When he says ..." when beating these things with a hammer - the magnets can quite easily get de-magnetised.....worst case scenario the magnets can even break and fall out of the rotor."...he is directly referring to the Rotor itself.
When he says ..." when beating these things with a hammer - the magnets can quite easily get de-magnetised.....worst case scenario the magnets can even break and fall out of the rotor."...he is directly referring to the Rotor itself.
Lechy never said he was ...."banging on the rotor". He originally said this;hillsy wrote: ↑Tue Jun 01, 2021 10:39 pmAnd BTW - you should take care when beating these things with a hammer - the magnets can quite easily get de-magnetised..... and then you'll wonder why your stator is not putting out decent voltage... worst case scenario the magnets can even break and fall out of the rotor....
Which the antagonistic one didn't understand or didn't read correctly. Proof of which comes when Lechy corrected him on with this;
Such lack of correct reading of what was said was the cause of the needless down-talking lecturing not in keeping with the Helping Spirit of this Tech Board.
- hillsy
- Joined a 1200cc Club
- Posts: 8846
- Joined: Wed Sep 17, 2014 12:43 am
Re: Rotor Remover
Hey Designer - when Lechy said give it a break, who do you REALLY think he was talking to?