Slack and a whinneing noise

Post Reply
tazmaniac_37752
Tricycles are Cool
Posts: 21
Joined: Tue May 05, 2020 12:05 pm
My Bike: Suzuki intruder

Slack and a whinneing noise

Post by tazmaniac_37752 »

My 96 vs800 has a whinneing noise that seems to be getting louder and also has slack in the drivetrain like a automobile with a worn rear differential. The whinneing sound changes as I change gears. Is there a common problem that causes this and what if anything can be done to fix it! That is if it needs to be fixed! Thanks!
I ain't done parking yet.

navigator
Joined a 1100cc Club
Posts: 5495
Joined: Thu Dec 29, 2016 12:33 pm
My Bike: VS800

Re: Slack and a whinneing noise

Post by navigator »

How many miles on the bike?
The splines on the rear end of the driveshaft, where it enters the rear gear at the rear wheel often wear out from lack of lubrication.
This will cause both of your symptoms.
Pull the rear wheel, then the rear gear.
You can tap the seal off and reuse it after regreasing. Use moly grease with 40% moly.
If the cup and shaft are severely worn, its often cheaper to buy a whole unit off of ebay.

navigator
Joined a 1100cc Club
Posts: 5495
Joined: Thu Dec 29, 2016 12:33 pm
My Bike: VS800

Re: Slack and a whinneing noise

Post by navigator »

I have one from an '07 for sale if you need it.

User avatar
FallenAngel
Joined a 950cc Club
Posts: 2256
Joined: Wed Apr 06, 2016 1:37 am
My Bike: Suzuki Intruder 1400
Location: Seattle,Wa

Re: Slack and a whinneing noise

Post by FallenAngel »

navigator wrote:
Sat Jun 12, 2021 7:45 am
I have one from an '07 for sale if you need it.
Hey Nav
Wasnt the 1400 cc final drive installed in an 800 cc an upgrade of some kind??
Higher gear ratio in the 1400cc??

navigator
Joined a 1100cc Club
Posts: 5495
Joined: Thu Dec 29, 2016 12:33 pm
My Bike: VS800

Re: Slack and a whinneing noise

Post by navigator »

FallenAngel wrote:
Sat Jun 12, 2021 4:39 pm
navigator wrote:
Sat Jun 12, 2021 7:45 am
I have one from an '07 for sale if you need it.
Hey Nav
Wasnt the 1400 cc final drive installed in an 800 cc an upgrade of some kind??
Higher gear ratio in the 1400cc??
IIRC the 1400 rear will bolt up with a slight elongation of the 3 mounting holes.
I don't remember if the shaft itself needed swapping due to length. :confused:

tazmaniac_37752
Tricycles are Cool
Posts: 21
Joined: Tue May 05, 2020 12:05 pm
My Bike: Suzuki intruder

Re: Slack and a whinneing noise

Post by tazmaniac_37752 »

Update: I just got back from a 2000 mile ride and it's still rollin so apparently it's not as bad as I thought.
I ain't done parking yet.

Post Reply