Page 1 of 1
Modified Flag Holder
Posted: Sat May 07, 2016 12:08 pm
by DevilsFan
Got a 3' piece of aluminum and (2) 5/16" threaded bolts for flag poles. Cut the aluminum to size then drilled holes, 2 for the "flagpoles" and 2 to match the Shad top case mounting base. Sandwiched the threaded bolts between the aluminum with lock nuts, then put 2 plastic donut thingies on top and bottom of the flags and capped each threaded bolt off with another lock nut.
I haven't ridden with it mounted yet but I will take the CTX out and see if my flagpole mount stays...or goes!
Re: Modified Flag Holder
Posted: Sat May 07, 2016 3:35 pm
by enforcer
Southern by the grace of God, ye hah!
Re: Modified Flag Holder
Posted: Sun Jul 03, 2016 7:36 pm
by ecbaatz
Nice holder but please note the American flag is on the right never on the left in a two mount setup.
Re: Modified Flag Holder
Posted: Tue Jul 25, 2017 6:36 am
by 1stlttightwad
To esbaatz .. But where does the 'If you don't like this flag I'll hep you pack." Go..besides up their azz.
Re: Modified Flag Holder
Posted: Thu Aug 15, 2019 7:29 am
by ecbaatz
1stlttightwad wrote:To esbaatz .. But where does the 'If you don't like this flag I'll hep you pack." Go..besides up their azz.
Never said I did not like the flag, in fact I support the southern flag even if I was born in the north. I spent 20 years in the Navy defending your rights. I was just pointing out proper flag etiquette. Did not mean to offend.
