Page 1 of 1

Cdi Box Relocation

Posted: Sat Jun 11, 2016 5:33 pm
by SFD213
So i wanted to remove the back seat and sissy bar from my 95 Intruder 800, so i did. Bow i have to figure out a place for the CDI box because it looks out of place on the top of the fender. Doubt putting it under the fender is smart, anyone have ideas or experience with this?

Re: Cdi Box Relocation

Posted: Sat Jun 11, 2016 6:59 pm
by enforcer
Not that I recommend it, but most switch to pod filters. It gives you a place to put the CDI under the seat.

Whole lot of work, just for looks.

Re: Cdi Box Relocation

Posted: Mon Sep 11, 2017 3:25 pm
by Pegdragger
enforcer wrote:Not that I recommend it, but most switch to pod filters. It gives you a place to put the CDI under the seat.

Whole lot of work, just for looks.
Haha. Yup lots of work but man pods make all the difference. If you cut the air box just right you can hide all of that extra electric sh*t under your seat.

Re: Cdi Box Relocation

Posted: Tue Sep 12, 2017 4:16 am
by Lechy
If you are going to fit pods, look here for what I did:
http://www.intruders-alert.com/viewtopi ... =13&t=6963

All bikes are slightly different so fine tuning would be up to you, I found that covering the foam with a pair of cut down sport socks helped.

[emoji41]

Re: Cdi Box Relocation

Posted: Tue Sep 12, 2017 8:15 am
by Herb
The ignition box is mounted to the bottom of the seat.

Re: Cdi Box Relocation

Posted: Tue Sep 12, 2017 8:48 am
by Lechy
Herb, on the 800's the igniter box is bolted in a recess on the rear fender.

[emoji41]

Re: Cdi Box Relocation

Posted: Tue Sep 12, 2017 8:49 am
by Lechy
Lechy wrote:Herb, on the 800's the igniter box is bolted in a recess on the rear fender, older models it is just bolted to the fender.

[emoji41]